A variety of problems may occur in the use of badminton hall floors, but many of them seem to be the quality problems of badminton hall floor products. In fact, most of them are caused by improper installation, and they will be reprocessed as a whole accidentally. Here is a detailed introduction.

To install the badminton hall floor, first cover the film. If the mulch film is not blocked, the ground water will excessively expand the local floor, resulting in uneven expansion of the upper and lower surfaces, tile warping and local cracks. Slight surface cracks are found locally on the surface, which can be repaired, and parts can be replaced in serious cases. Because the floor is dry and wet, in the wet summer in the north, and in the winter, there is heating, the spring thrust of the fixed floor may be lost or insufficient, and the floor cannot be restored to its original position in summer, and there will be gaps between plates.

Badminton hall floor Before installing the floor, if the cement floor is uneven, the gap between the floors will also occur. Replace the spring, use a puller to re tension the floor and pave it after leveling. The local floor arches, expands and feels trampled. The expansion joints reserved by the construction personnel are insufficient, and the ground is arched. The construction personnel did not set the transition zone, or the expansion joints were reserved too much during paving, which caused arch. The room span is large, and transition buttons need to be installed properly. The coating film breaks or breaks at the floor joints. The main problems in construction are uneven plate striking or uneven force.

Slight tension and fracture occurred locally. The expansion joint is not reserved enough during construction, and it is slightly arched after expansion and extrusion. Slight damage can be repaired with paraffin, and serious damage can be replaced with paraffin. There is abnormal noise when stepping on the floor. The crude oil surface is uneven, but the flat surface treatment is insufficient during installation. It is not bonded, or the amount of adhesive is small, or the position of adhesive is incorrect, there is no joint or fixed joint effect, and the grooves rub against each other to produce sound. Inappropriate gaps are left around the floor, or the floor is not sealed, local or overall expansion of the floor, and friction sound is generated when the groove floats up and down.